This paper presents a new high step-up DC-DC switched-mode converter in which not only the Input and output ports can be connected to a common ground, but also the service time of the Input source is extended due to Continuous Current injection to the proposed power converter. Furthermore, the fast dynamic response is offered by minimum phase characteristics. This key feature is achieved by making the proposed converter’s control to output transfer function, free from the right half plane zero (RHPZ). Full description of the operation principles, theoretical analysis related to steady-state operation, and also the small-signal modelling derivation of the proposed converter, are presented in this paper. In the end, to confirm all the merits of the proposed converter and accuracy of theoretical analysis, a sample 25 V - 100 V laboratory prototype DC-DC converter with 100W output power has been implemented, and the main experimental results have also been outlined.

In this paper, a single switch transformer-less DC-DC converter with Continuous Input Current for photovoltaic applications is proposed. The suggested configuration utilizes a CL1C2D2 structure to achieve a high voltage gain and alleviate voltage pressure on the semiconductor components. This design enables a significant increase in voltage output with a minimal turns ratio, leading to reduced size, weight, and cost of the converter system. The reduction in turns ratio of the coupled inductor results in lowered voltage stress on the semiconductor elements. Additionally, employing just one power switch in the converter simplifies control and reduces expenses. With its Continuous Input Current, this converter is particularly well-suited for integration in photovoltaic systems. Simulation results conducted using PSCAD/EMTDC software validate the efficacy of the proposed power converter. Furthermore, the maximum power output of the photovoltaic module through an MPPT (Maximum Power Point Tracking) controller under varying irradiance levels is determined, and simulations are executed using PSCAD/EMTDC.

The objective of this paper is to propose, study and analyze a non-isolated high step-up SEPIC-based DC-DC converter for photovoltaic applications. The proposed structure is based on the SEPIC converter and utilizes a two-winding coupled inductor along with an improved voltage multiplier cell in order to enhance the output voltage level. Moreover, a passive voltage clamp is used to reduce the voltage stress on the main switch and recover the energy stored in the leakage inductance of the coupled inductor. Hence, an active switch with low RDS-ON could be employed. Meanwhile, due to soft switching condition at turn-off instant of diodes, their reverse-recovery problems are solved. Furthermore, the presented converter has the merits such as Continuous Input Current, high efficiency and low cost and size which make it a promising solution for photovoltaic applications. At the end, the converter is compared to different types of DC-DC converters to show its advantages over the converters designed before. In order to verify the performance of the converter, a 200-W laboratory prototype is implemented and experimental results are taken and depicted. Results prove the feasibility and functionality of the presented converter for photovoltaic systems.

This paper investigates a fundamental issue in AC-DC rectifiers that are specifically used as charger for electric vehicle (EV), i. e. the total harmonic distortion (THD) of Input Current waveforms. Firstly, the topology of two-stage charger along with the corresponding control scheme is reviewed. Then, the research gap namely high harmonic distortion of Input Current is identified and analyzed. A revision of the conventional control method with the aid of virtual resistant is proposed and investigated from the circuit perspectives. Finally, simulation results are delivered to validate the analysis and the reduction of THD in the Input Current waveform. this is proposed method, the steady state is studied.