Dear Editor: Recently, with great interest we read the review article by Zeraati et al. entitled "A review article: access Recirculation among end stage renal disease patients undergoing maintenance hemodialysis" in your most valuable journal. The author summarized some of observations about causes and clinical significance of arteriovenous (AV) fistula Recirculation, techniques for accurate assessment and main source of pitfall in calculation of access Recirculation (AR). Hemodialysis AR occurs when the blood urea concentration in arterial line is lower than that of systemic circulation, indicating that dialyzed blood returning through the venous needle reenters the HD machine through the arterial needle.

Treatment for end stage renal disease patients is based on dialysis; however, the presence of access Recirculation (AR) decreases dialysis efficiency and adequacy. This study was conducted to determine the Recirculation rate in dialysis patients undergoing hemodialysis through using a permanent catheter. 60 patients including 23 males and 37 females were enrolled. Mean age of the participants was 57. 66 (± 14. 08) years. Mean AR in the subjects was 9. 36%, and 16 (27%) of patients had mean AR above 10%. Moreover, there was a significant correlation between AR and catheter longevity (P <. 001). It is suggested to limit the use of permanent catheters to specific cases and not to use them in place of arteriovenous fistulas.

Background: Prior investigators have demonstrated that determining Recirculation in aterovenous fistula is a reliable tool for evaluation of hemodialysis. Dialysis patients were reported to be 22000 cases in our country, for whom aterovenous fistula were prepared with different techniques. To our knowledge, there is not any study clarifying the quality of hemodialysis in the affected subjects. Materials and methods: A descriptive study was conducted on 97 patients in Hasheminejad Dialysis Center in Tehran, all of whom had native aterovenous fistula. Recirculation was determined by low blood flow technique. Type and site of the fistula were compared according to the Recirculation rate. Results: Recirculation varied from zero to 16% with the mean of 2.5%. The highest mean of Recirculation was found in end to side proximal fistulas and the lowest was reported in side to side proximal fistulas. Conclusion: Recirculation was within the normal range. It does not show correlation with site and type of fistula at flow of 300 ml/min.

Introduction: The measurement of Arterio-Venous (A-V) Fistula Recirculation has important diagnostic implications because the efficiency of haemodialysis (HD) may be limited, resulting in dialysis delivery being less than that prescribed. The purpose of the study is to determine its prevalence and causes in our HD patients.Methods and Materials: We randomly selected 100 end stage renal disease patients with AV fistula that they were on HD more than 3 months. The degree of Recirculation was also measured with Urea based two needle technique method. For each patient distances between arterial and venous and distances of needles from fistula and its directions was recorded.Echocardiography and A-V fistula Color Doppler Ultrasound were also performed.Results: Blood flow rate and dialysate flow rate were 300 mL/min and 500 mL/min respectively.The prevalence of A-V fistula Recirculation was 17% (17patients).Average degree of Recirculation between these patients was 9.56±2.32 %. The most common cause was misplacement and or misdirection of needles (17 patients). The second cause was heart failure with Ejection Fraction>40% (8 patients). No difference was seen between diabetic versus non diabetic (P=0.28) and hypertensive versus normotensive (P=0.21%) HD patients.Conclusions: A-V fistula Recirculation is common occurrence in HD patients and the most common cause of Recirculation is misplacement and or misdirection of needles so we should have more emphasis on education and training of HD staffs.

The impeller of a centrifugal compressor is traditionally designed using some formula for only one design point which makes it less efficient in all other situations. This is especially important for compressors not experiencing a constant working condition. To improve the performance at low mass flow rates and retard the surge, an innovative concept is introduced for a centrifugal compressor. In this method pressurized air is injected at the compressor inlet to improve the flow field. With better incidence angle, related losses at off design conditions are minimized and the surge is delayed. This system is designed, modeled and adjusted for providing an optimal flow pattern at the inlet. Its implementation on a compressor has shown an increase of efficiency at low mass flow rates. It has also improved flow pattern in impeller passages and decreased the blade loading near surge condition. It is also shown that the swirl generator system can be fed up from the compressor volute or diffuser, and thus widening the compressor performance map by retarding the surge margin.

Electro oxidation processes are developed throughout the world for ambient temperature destruction of organic wastes. Several of these processes are based on mediated electrochemical oxidation. This article presents the experimental results of electro chemical study based on mediated electrochemical oxidation process conducted for synthetic organic ion exchange resin materials. Investigation was carried out using the traditional noble metal oxide coated anode, ruthenium oxide-titanium and the mediator used for the experiment was ferrous sulphate, with sodium chloride as supporting electrolyte. The concentration of sodium chloride was maintained at 5, 8, 12gm/L. The experiment was carried out in batch Recirculation reactor with varied current densities for various flow rates. The study highlighted that in batch reactor set up the best effect of total organic content reduction was found to occur at 3.75A/dm2 with flow rate of 20L/h. The simulated studies were carried out for different volumes of effluent and current densities. A graphical analysis was made between the experimental and simulated values and it was found that both the values are very close.